Total Station Manual
69
ƻ
1 After finishing setting the
job, setting the station and
setting the orientation, press
[F4] to start the application in
the Pre-Setting menu.
[F4]
ƻ
2
Input the point name, and
then press [ENT] to move to
next input item to input prism
height.
Input
point
name
+
[ENT]
ƻ
3 Input the prism height and
then press [ENT] to move the
cursor to next input item. If
needed, input the code.
Input
prism
height
+
[ENT]
ƻ
4 Press [F1](ALL) or press
[F2](DIST) and [F3](REC) to
start measuring and record the
measured data. This data
contains angle, distance and
coordinates. Press [PAGE] to
switch the display mode of the
data.
[F1]
or
[F2]+[F3
]
ƻ
5
After finishing measuring
one point, the point name
automatic plus one. Press
[F1](ALL) or press
[F2](DIST) and [F3](REC) to
continue measuring next
To Next Page
Loading...
