Total Station Manual
76
z Manual input stakeout point
Press key [Coord.] or [SO-PT] to manual input stakeout point coordinates and
then continue staking out.
[Coord.]:
Press [Coord.] and then input a target point’s coordinates. Saved this point into
job and continue staking out.
Steps Key Display
ƻ
1
Press [F4] (
Ę
)toview
the second page of soft
keys.
[F4]
ƻ
2Press[F2](Coord.) to go
to Input Coord. Screen.
Input point name and
coordinate of the stakeout
point. After input one item,
the curser will move to next
input item.
[F2]
+
Input point
name and
coordinates
+
[ENT]
ƻ
3
After finishing inputs,
press [F4](OK) to save the
data. And then back to
Stakeout screen. Start to
stakeout the input point.
To Next Page
Loading...
