Total Station Manual
82
ƻ
2
Press direction key and
move the cursor to input prism
height item. Input the prism
height and then press [ENT] to
confirm.
Ę
+
Input
prism
height
+
[ENT]
ƻ
3
Aim at the prism. Press
[F2](DIST) to start measuring
and calculate the differences
between measured point and
stakeout point.
The arrow’s direction is the
direction of the prism need to
move.
[F2]
ƻ
4 Move the prism according
to the direction of the arrow to
make the value of
Length equal 0m.
Arrows Meaning:
Ę
: Move the prism close to
the station.
Ė
: Move the prism far away
the station.
In the process of staking out,
if using the Repeat
Measurement or Tracking
Measurement, the calculation
of the differences between
measured point and stakeout
point can be displayedin real
time and convenient.
To Next Page
Loading...
