Total Station Manual
88
ƻ
4 Aim at the prism. Press
[F2](DIST) to start measuring
and calculate the differences
between measured point and
stakeout point.
[F2]
ƻ
5 Turn the instrument
telescope to make the
Ƹ
Hz
equal 0°00’00” and command
the staff to move the prism at
the same time.
Ƹ
Hz is positive: The
stakeout point is in the left
side of measured point. Move
the prism to left.
Ƹ
Hz is negative: The
stakeout point is in the right
side of measured point. Move
the prism to right.
ƻ
6
Set and aim at the prism
in the direction of
Ƹ
Hz =
0°00’00”. Press [F2](DIST)
to start measuring and
calculate the differences
between measured point and
stakeout point.
Ƹ
is positive: The
stakeout point is is closer to
the station. Move the prism
close to the station.
Ƹ
is negative: The stakeout
point is is farther to the
station. Move the prism far
away the station.
[F2]
To Next Page
Loading...
