Screen 11 - Settings
The following instrument settings may be maintained:
1 – Prompt ID: Press ‘Key 1’ to prompt for ID code for each sample reading, answer ‘Yes’ or
‘No’ accordingly.
* – Temperature: This option is not available on the G200 range of instruments.
3 – Date: Press ‘Key 3’ to switch the date format between dd/mm/yy and mm/dd/yy formats.
4 – Auto Off: Press ‘Key 4’ to auto switch off the instrument when not in use. Toggle between
Auto Off: Yes or No. If set to Yes, the instrument will switch off after ten minutes if not in use.
Flow Fail
The ‘Flow Fail’ option enables the operator to adjust the instrument flow fail detection point should it
fail in normal operation with a clean filter.
The instrument’s internal pump can be stalled when pulling against a vacuum or through a blocked
filter. This is indicated by a flashing pump icon ; to prevent damage to the pump, the pump will
switch off after a few seconds. Press the ‘Pump’ key again to remove the flashing pump icon.
Note: Dirty or discoloured filters should be changed before use. Filters that have drawn in water
should be changed immediately to prevent damage to the instrument.
From the ‘Main Read Screen’ press the ‘Menu’ key on the instrument panel.
Press ‘Key 2’ to display the ‘Utilities’ menu.
Press ‘Key’ 5 to select ‘Flow Fail’ and the following screen is displayed:
Screen 12 - Adjust flow fail
To Next Page
Loading...
