Administrator Mode
69
4 4
Note:
1. If an infrared illuminator is installed for outdoor surveillance, it is
suggested to use the Trigger by Input or the Trigger IR by D/N
function to avoid incorrect judgment of lighting and hence the action
of the IR cut filter. See Infrared Illuminators in the Hardware
Manual.
2. If you select Trigger by Input / Trigger IR by D/N option, make
sure you have set D/N as Auto and configured its sensitivity level.
Iris Type: Note this function is not supported for the camera with fixed
lens or fixed iris. This field shows the iris type (DC-Iris or P-Iris) of
your GV-IP Camera.
Auto Iris: The option is designed for auto iris lens (DC-Iris or P-
Iris). Enable the auto iris function when the scene appears fuzzy
and the Flicker Less function does not help to improve the
situation.
BLC: Note this function is not supported by GV-BX2600. Select On to
enable Backlight Compensation (BLC). This function is used to adjust
the color intensity of scenes with strong light at the background.
Note: To access the BLC function in PTZ camera, see Other, Image
Settings in the Hardware Manual.
IR Light: Note this function is only available for Target Series, Ultra
Box Camera, IR Arctic Box Camera, Bullet Camera, Ultra Bullet
Camera, PT Camera, Vandal Proof IP Dome and Fixed IP Dome.
Select Auto for automatic switch between day mode and night mode
depending on the amount of light detected. Select Off to completely
disable IR LEDs.
To Next Page
Loading...
Need help?
General
