1.3.6 Replacing the Silica Gel Bag
Once the housing of GV-LPC1200 / LPR1200 is opened, you must replace the original silica
gel bag with a new one.
1. Loose the screws holding the camera’s lid with the torx wrench.
Camera’s Lid
Figure 1-30
2. Open the camera’s lid and you will find a silica gel bag attached to the interior of the lid.
Silica Gel Bag
Figure 1-31
3. Remove the silica gel bag and place a new bag back to its original position.
4. Fasten the camera’s lid within 2 minutes of replacing the silica gel bag.
IMPORTANT: The silica gel loses its effectiveness when the dry camera is opened. To
prevent the lens from fogging up, replace the silica gel bag every time when you open the
camera and conceal the gel bag in the camera within two minutes of exposing to the open air.
30
To Next Page
Loading...
Need help?
General