23
1.6.10 GV-SNVR1611 Rear View
Figure 1-11
No. Name Function
1 Megabit PoE Ports
Connects to cameras, delivering power and network
connection to the cameras.
2
Megabit Ethernet Port (WAN) Connects to a network.
3
Audio Line In Port Connects to a microphone.
4
Audio Line Out Port Connects to a speaker.
5
VGA Output Connects to a VGA monitor.
6
I/O Panel Connects to 4 input and 1 output devices
7
HDMI Output Connects to a HD TV.
8
USB 3.0 Port
Connects to a keyboard, mouse, USB flash drive or
GV-Joystick V2.
9
Power Input Connects to power supply.
10
Power Button Turns the system on or off.
IMPORTANT: Only connect GV-SNVR1611 to the Internet through its WAN Port (No. 2) as
opposed to any of the 16 PoE ports (No. 1), as they are only for connecting to IP cameras
and have limited network connection.
Note: GV-SNVR1611 does not have a load default button. To restore factory settings
manually for:
˙ Firmware V3.09 or earlier, right-click the mouse five times during the startup screen.
˙ Firmware V3.10 or later, click both the left- and right-click of the mouse 10 times within 3
seconds during the startup screen.
Or see 6.2.5 Restoring to Factory Default Settings for loading default via GV-IP Device Utility.
To Next Page
Loading...
Need help?
General
