System Configuration
76
3
3.3.2 WiFi
Note this function is only applicable to GV-SNVR0411 / 0811.
Figure 3-10
Before using the WiFi function, make sure to insert a GV-WiFi Adapter.
To enable WiFi, click Active.
SSID: Click Search to detect WiFi networks within the range of GV-SNVR.
Encryption: Select the type of encryption of the selected network.
Password: Type the login password for the network selected.
IP Configuration: Select DHCP for the network to assign an IP address for the WiFi
adapter, or select Static to type the IP information, including IP address, Subnet Mask,
Gateway and/or Primary and Secondary DNS.
WPS: Alternatively, you can connect GV-SNVR to your router through WPS. To do this,
enable WPS on your router, click the WPS button and type the required information.
IMPORTANT: Do not set the WiFi Subnet to be the same as the LAN, or it will result in a
conflict of the system’s network.
To Next Page
Loading...
Need help?
General
