System Configuration
86
3
3.7 Event
Note this function is only applicable to GV-SNVR0412 / 0812 / 1611 / 1612.
In the Event settings, you can configure GV-SNVR to trigger output alarms, start video
recording, send e-mail alerts and/or trigger buzzer upon motion detection and input trigger
events.
Figure 3-19
Type: Select the type of event you wish to configure, between Alarm In or Motion.
Alarm In: When the type of event is selected, select the desired input module from
1 ~ 4.
Motion: When the type of event is selected, select the desired camera channel
from 1 ~ 4 / 1 ~ 8 / 1 ~ 16 respectively for GV-SNVR0412 / 0812 / 1611 / 1612.
State: When Alarm In is selected, select Active to enable the input module.
Normal State: When Alarm In is selected, select between Open circuit or Closed
circuit to define the module as normally open or normally closed, respectively.
People counter: For GV-SNVR0412 / 0812 with firmware version V1.05 / 1.10 or
later only, see 3.6.2 Regulating People Flow with GV-IP Cameras.
To Next Page
Loading...
Need help?
General
