What to do if the printed object comes loose from the printing bed on German RepRap X350?
If your printed object detaches from the printing bed of your German RepRap 3D Printer, try cleaning the printing bed. If needed, lubricate it with acetone, unless you have a BuildTak overlay. Also, the printing overlay may be worn out (PET film), or the distance between the nozzle and the printing board may be incorrect.
What to do if German RepRap X350 3D Printers stop printing mid-process?
If your German RepRap 3D Printer stops printing mid-process, check the power supply. The SD card might be faulty, or the Gcode may be invalid.
How to fix Hot-End when it doesn't heat up in German RepRap X350 3D Printers?
If the Hot-End of your German RepRap 3D Printer isn't heating up, check if the Hot-End plug connection is firm enough.
How to troubleshoot German RepRap X350 3D Printers when the device doesn't turn on?
Check the power supply of your German RepRap 3D Printer.
Steps for initial setup and checks after delivery.
Step-by-step guide to correctly level the printing bed.
How to use adjustment screws for precise bed levelling.
Steps for connecting the printer to a local network.
Safe procedure for removing filament from the extruder.
Steps for replacing one filament with another, including temperature settings.
Guide for installing the recommended 3D printing software.
Method for loading print files from an SD card.
Safely detaching finished prints from the build plate.
Cleaning procedures for the extruder nozzle and heating block.
Guide to choosing appropriate printing materials and their properties.
Solutions for printer power, hot-end, and bed heating problems.
Troubleshooting steps for mid-process print failures.
Guidelines for safe handling and use of the power adapter and cord.
Importance of correct mains voltage and fire risk awareness.
General| Brand | German RepRap |
|---|---|
| Model | X350 |
| Category | 3D Printers |
| Language | English |
To Next Page