German RepRap X350 - ABS Filament Details; ABS Specification Data

X350 3D-Printer Quick Start Guide
Seite: 16/29
Stand: 2016/03/24 13:55
© German RepRap GmbH 16/29
ABS (Acrylonitrile butadiene styrene-copolymer)
Acrylonitrile butadiene
styrene-copolymer (ABS)
Acrylonitrile butadiene styrene-copolymer (short ABS) is a synthetic terpolymer of three
different kinds of monomers, acrylonitrile, 1.3 butadiene and styrene and belongs to the amorphous
thermoplastics. The proportions can vary from 15 to 35% acrylonitrile, 5 to 30% butadiene and 40 to
60%.
Specification
The following specification refers to the ABS distributed by us.
Density: 1,05 g/cm3
●
Melt mass flow rate MFR: 5-9 (220 °C/10 kg), g/1 0 min
●
Melt volume rate MVR: 5-9 (220 °C/10 kg), cm 3/10 min
●
Tensile strength: 2400 MPa (23°C)
●
Impact strentgth: 130 (bei 23°C), 100 (bei – 30 °C) kJ/ m2
●
Notched bar impact test Izod: 25 (bei 23°C), 12 (bei -30° C) kJ/m2
●
VIcat- softening temperature: ~ 100 °C
●
Melting temperature: from ~ 220 °C
●
Source
Acrylonitrile butadiene styrene
PLA (Polylactic acid)