X350 3D-Printer Quick Start Guide
Seite: 20/29
Stand: 2016/03/24 13:55
© German RepRap GmbH 20/29
Important notes
Return / Original wrapping
Please retain this documentation and the original package of this printer in case you need to ship it
for repairs or to a new address. 3D printers are inherently sensitive to bumping or knocking and are
best protected in their original box. Returns that are not properly packaged cannot be repaired under
warranty.
Operation
Do not cut the power while the printer is active. This can lead to the loss of data as well as damage
some electronic components.
Other matters
All information in this guide is current at the time of printing. We reserve the right to amend the
hardware, software or the documentation without prior notice. The latest information will always be
available at http://www.germanreprap.com.
Toxic fumes
Depending on the plastic being used there is a danger of toxic fumes developing if the printer is
running too hot for that filament. Always make sure to set the correct temperature for the plastic used.
The maximum temperature is generally printed on the filament spool and can also be looked up on
our website. (http://www.germanreprap.com).
Safety cut-off
The device has a thermal protection mechanism built-in. If the temperature exceeds the safe working
limit the printer turn itself off after issuing a warning message.
To Next Page
Loading...