X350 3D-Printer Quick Start Guide
Seite: 21/29
Stand: 2016/03/24 13:55
© German RepRap GmbH 21/29
Maintenance
Every 12 months the printer has to be serviced by trained personnel. This includes checking the
safety devices as well as all mechanical components. German RepRap offers this as a service. Please
contact us via info@germanreprap.com for more details.
Work on a mains power supply should only be carried out by trained specialists. It is essential to note
the safety regulations. Property or personal damage may be caused by improper installation, which
the installer bears liability for.
Proper handling of the chemicals necessary for maintenance and care is obligatory, as well as
complying with the regulations and operation notes regarding the chemicals. Directions of the
manufacturer must be followed at all times and appropriate protective clothing has to be worn.
Property or personal damage may be caused by improper use of the chemicals, which the operator
alone bears liability for.
To Next Page
Loading...