X350 3D-Printer Quick Start Guide
Seite: 5/29
Stand: 2016/03/24 13:55
© German RepRap GmbH 5/29
System requirements
These system requirements are exclusive to the use with the included software Simplify3D™.
Intel Pentium 4 or better
●
2GB RAM or more
●
USB from 1.1 optional
●
Windows XP or newer
●
Mac OS X 10.6 or newer
●
Ubuntu/Debian Linux
●
OpenGL 2.0
●
Starting up
Instructions
During shipment of the X350 it may happen that the limit switches shift. This should be checked, and
adjusted.
Warning: Do not fasten the screws too tightly!
The heated printing bed (ceramic) of the X350 is covered in a PET film. ABS and PLA stick to this film
very well. However, this film can get damaged, or lose adhesion after some use. In this case, you can
acquire a new film from us.
The processing PLA (Polylactic acid) is also possible without the PET film on the printing bed. You can
find further details about that in the Overview of filament types in our Wiki, or in the section of the
same name within this instruction manual.
Setting up the printer
The printer is to be plugged into a 230V power outlet via the power cord. The included network cable
allows you to connect the printer to the home network. This is also necessary if you want to use the
printer through the wireless network later. For the first setup, an Ethernet connection is required.
To Next Page
Loading...