X350 3D-Printer Quick Start Guide
Seite: 22/29
Stand: 2016/03/24 13:55
© German RepRap GmbH 22/29
Safety notes
Power supply
Always ensure that the power lead has not been damaged. Disconnect the device immediately if the
power lead shows any sign of damage. Have the power supply inspected by an authorised electrician.
Only use the power supply that came with the printer. An electric shock from a faulty power lead can
be fatal!
Only use the power supply if your mains voltage is 100-110V or 220-240V AC. Only use the correct
power lead for your mains socket.
Cleaning
Pull the power plug before cleaning the device. Use a dry cloth and only clean the surface.
Handling the chemicals necessary for maintenance and servicing has to take place properly and
under adherence to of for this valid regulations and application notes to the chemicals. To the
specifications of the manufacturers absolutely for this is to be responded, it is appropriate protective
clothing to be carried, and the dosage regulations are to be kept exactly.Special and personal injury
can be caused by inappropriate handling chemicals, for which alone the operator is responsible.
Playing children
Touching the internal parts of the power supply can cause an electric shock!
Mains voltage
Only operate the device with the indicated supply voltage (visible on the backside of the device or on
the external power supply) The device must not be connected to the mains until all connections were
double checked.
There is a fire hazard if the mains voltage is too high!
To Next Page
Loading...