Gesipa taurus 2 - Not Possible to Reload the Speed Rivet; Rivet Setting Tool Reloads More Than One Rivet

32
11. Warranty
The applicable terms and conditions of guarantee shall apply and can be viewed under follow-
ing link: www.gesipa.com/agb
12. Declaration of conformity
pp Dr. Richard Gärtner
10.3 The rivet setting tool reloads more than one rivet
Cause Remedy
Jaws are dirty Clean and oil sliding surfaces (point 8.1)
Jaws are worn Replace (point 8.1)
We hereby declare that the design and construction of the tool named below, as well as the
version that we have put on the market, complies with applicable fundamental health and
safety requirements stipulated in EU directives. Tool modications made without our authori-
sation shall render this declaration void. The safety information in the product documentation
provided must be observed. This document must be retained.
TAURUS
®
1-2 Speed Rivet
• 2006/42/EG
• DIN EN ISO 12100:2011
• DIN EN ISO 11148-1:2012
• DIN EN 82079-1:2013
Authorised documentation representative:
GESIPA Blindniettechnik GmbH
Nordendstraße 13-39
D-64546 Mörfelden-Walldorf