58
Set Supervisor/User Password sets the supervisor/user password. You
can set the supervisor/user password to be required for starting up the
system and/or entering BIOS Setup.
Strong Password enables or disables strong password. When enabled,
the password you set must contain at least one upper-case letter, one
lower-case letter, and one digit.
Password Configuration sets the minimum password length. Enter the
number in the input field and select [Yes]. The number should be
between 4 and 64.
Password on Boot allows you to enable or disable the entering of
password for booting up your system.
Secure Boot Configuration You can access this item only after setting
the Supervisor Password.
Secure Boot enables or disables Secure Boot. Secure Boot is a feature
that helps prevent unauthorized firmware, operating systems, or UEFI
drivers from running at boot time.
Delete all Security Boot Keys deletes all secure boot variables.
Restore Factory Defaults resets secure boot variables to manufacturing
defaults.
Load MS UEFI CA Key determines if the Microsoft UEFI CA key will be
used to sign non-Microsoft UEFI boot loaders, such as Linux or other
operating systems.
Set X SSD 0 / SSD 1 User Password (where X is the interface, which can
be PCIe or SATA depending on your model) sets the password for locking
the SSD. After setting a password, the SSD can only be unlocked by the
password no matter where it is installed.
NOTE: The SSD 1 item appears only when your model has the second SSD.
Security Freeze Lock enables or disables the “Security Freeze Lock”
function. This function is only applicable to SATA drives in AHCI mode. It
prevents attacks on the SATA drive by freezing the security state of the
drive at POST and also when the system resumes from S3.
TPM Setup Menu
Change TPM State allows you to select between No Operation and Clear.
Intel Trusted Execution Technology enables utilization of additional
hardware capabilities provided by Intel® Trusted Execution Technology.
To Next Page
Loading...
