Getac V100 - Connecting to a Wireless Network

Turning Off/On the WLAN Radio
Your computer has a built-in Fn+F2 WLAN hot key to switch the WLAN
on/off. If you need to temporarily turn off the radio, press Fn+F2. To resume
network connection, press Fn+F2 again.
It takes approximately 30 seconds for your computer to make a successful
WLAN connection and approximately 10 seconds to disconnect.
Connecting to a Wireless Network
To connect to a wireless network:
1. Make sure that the WLAN radio is on (controlled by Fn+F2).
2. Click Start  Programs  Intel PROSet Wireless  Intel PROSet
Wireless.
3. If any wireless network is detected, the following window appears on
screen.