Repair and adjustment
38
Service instructions
5015108-00 Edition 0403
Setting detergent and rinse-aid quantities
This must only be done by authorised personnel.
The machine is connected to the electricity supply and some components are live.
• Dispense 100 ml of the relevant substance into a measuring beaker. Check that the suction
hose and pump are full before the check.
• Push the suction hose down into the beaker and measure the consumption during an entire
cleaning program. Lift up the hose when reading the volume. Adjust if necessary, and repeat
the measurement until the amount of detergent conforms to the manufacturer’s
recommendations.
• If necessary, adjust the dosing time in the service program.
To Next Page
Loading...
