What to do if the Getinge WD15 CLARO machine is overfilling?
If the Getinge Laboratory Equipment machine is overfilling, you should: 1. Check the hoses for leaks. 2. Check the drainage system to ensure drainage water doesn't overflow the chamber. 3. Check the function of the level sensor. 4. Check that the water level in the condenser does not increase and form a water lock.
What to do if there is overfilling in the condenser of Getinge WD15 CLARO Laboratory Equipment?
If there is overfilling in the condenser of the Getinge Laboratory Equipment, you should: 1. Check the function of the condenser’s drainage pump. 2. Check that water can be pumped out of the drainage system. 3. Check the function of the level sensor.
What to do if there is an unlocked door on Getinge WD15 CLARO?
If the door on the Getinge Laboratory Equipment remains unlocked, you should: 1. Check that nothing is trapped in the door. 2. Check that the door locking switch (-S01) is activated on door locking.
What should I do if the Getinge WD15 CLARO Laboratory Equipment chamber empties slowly?
If the chamber of the Getinge Laboratory Equipment empties slowly: 1. Check the function of the drainage pump. 2. Check the function of the level sensor. 3. Check that water can be pumped out of the drainage system.
What should I do if the Getinge WD15 CLARO chamber fills slowly?
If the chamber of the Getinge Laboratory Equipment fills slowly: 1. Check that the cover inside the chamber opens for incoming water. 2. Check the function of the level sensors. 3. Check the function of the filling pump for the water softener.
What to do for water leakage in the Getinge WD15 CLARO Laboratory Equipment dryer?
If you observe water leakage in the dryer of the Getinge Laboratory Equipment, you should: 1. Check the check valves in the drying channels. 2. Check the function of the sensor.
What to do if Getinge WD15 CLARO Laboratory Equipment shows an incorrect temperature indicator?
If the Getinge Laboratory Equipment shows an incorrect temperature indicator, check the temperature sensor for an open-circuit or short-circuit.
What to do if Getinge Laboratory Equipment shows a faulty independent temperature sensor?
If the Getinge Laboratory Equipment indicates a faulty independent temperature sensor, check the temperature sensor for an open-circuit or short-circuit.
What does it mean if there is high temperature in wash chamber of Getinge WD15 CLARO Laboratory Equipment?
If there is a high temperature in the wash chamber of the Getinge Laboratory Equipment, it means the temperature in the chamber is more than 5°C above the highest reference point.
What to do if there is low pump pressure in Getinge WD15 CLARO Laboratory Equipment?
If there is low pump pressure in the Getinge Laboratory Equipment, you should: 1. Check that the shut-off valves for the water are open and that water is reaching the machine. 2. Check the function of the sensor.
General| Type | Washer-disinfector |
|---|---|
| Cleaning Performance | Complies with EN ISO 15883 |
| Power Supply | 230V, 50/60Hz |
| Washing levels | 2 levels |
| Temperature Range | Up to 93°C |
| Programs | Multiple programmable cycles |
| Water Consumption | Approx. 15 L per cycle |
| Control System | Microprocessor-controlled with touch panel |
| Application | Cleaning and disinfection of laboratory glassware and utensils |
To Next Page
