Operating instructions MSA 4 Index
Index Page
1 Introduction 1
1.1 Product Description 1
1.2 Components description 2
1.2.1 Operation Controls 2
1.2.2 Display 3
1.2.3 Electrical switch 3
1.2.4 Ambient temperature sensor 3
1.2.5 USB interface 3
1.2.6 Power Cable 3
1.2.7 Welding Cable 3
1.3 Barcode Reader 4
1.4 Extension Cables for Power Supply 5
1.5 START/STOP Card 5
2 Fusion process 6
2.1 Overview of operating procedure 6
2.2 Switching On 7
2.3 Enter work site details 7
2.3.1 Operator Identity 7
2.3.2 Job number 8
2.4 Connect fitting 8
2.5 Enter fusion data 8
2.5.1 Barcode insertion 9
2.5.2 Manual insertion 10
2.6 Process incomplete pre-alert 10
2.7 Second Welding Number 11
2.8 Fusion preparation and aligner check 11
2.9 Traceability 12
2.10 Pipes Length 13
2.11 GPS 13
2.12 Fusion process 14
2.12.1 Welding phase 14
2.12.2 Cooling time 15
3 Configuration settings 16
3.1 Language 18
3.2 Calendar 18
3.3 Manual Mode 18
3.4 Fusion preparation 19
3.5 Service 19
3.6 Traceability 19
3.7 Welder identification 19
3.8 Memory management 20
3.9 Second Protocol Number 21
3.10 Pipes Length 21
3.11 Export Configuration 21
3.12 Additional configuration 22
3.13 Machine Owner 22
3.14 Infotext 22
To Next Page
Loading...
Need help?
General
