83
Updating the base firmware
Gigaset SL910/910A / GBR/IRL / A31008-M2300-L101-1-7619 / settings-pabx.fm / 23.08.2011
Version 4.1, 21.11.2007
Starting a firmware update
Prerequisite:
u The phone is connected to the Internet (i.e., connected to a router, ¢ page 81).
u The phone is in idle status, i.e.: no calls are being made, there is no internal con-
nection, no handset has opened a menu on the base.
Starting the firmware update manually
¤ In the Settings menu (¢ page 24), touch [ Ê System].
¤ Scroll to Firmware Update. ¤ Touch the corresponding ’. ¤ Enter the system
PIN and confirm with è.
¤ Touch Update Firmware.
If a new version of the base firmware is available, message New firmware available
- Update? is displayed.
¤ Press Ye s to confirm.
Setting the automatic firmware update
¤ In the Settings menu (¢ page 24), touch [ Ê System].
¤ Scroll to Firmware Update. ¤ Activate/deactivate the function with the button
next to Automatic Check.
If the function is activated, the base will check daily whether a new firmware ver-
sion is available. If this is the case, you will receive the message Start download?.
¤ Press Ye s to confirm.
If you answer the prompt with No, you will no longer be informed about this
firmware update. The message will not be displayed again until the next firmware
version is available. You can perform the firmware update manually (
¢ page 83).
Please note
u The firmware update can take up to six minutes, depending on the quality of
your DSL connection.
u During the update, the registered handsets temporarily lose their connec-
tion to the base.
Please note
If the phone is not connected to the Internet at the time the check for new
firmware is carried out (e.g., no router connection), then the check will be car-
ried out as soon as the phone is reconnected to the Internet.
To Next Page
Loading...
