EasyManua.ls Logo

GLEANER R66 - Page 31

Default Icon
51 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
General Information
01-26 79032996 A Rev.
Primary Engine Fuel Filter Drain any accumulated water from fuel
filter
Place cloth or container under filter to
catch any fluids before opening drain
valve.
Shaker Shoe Chaffer and
Sieve
Remove and accumulated straw, cobs,
etc.
Tire Pressure Check and inflate as needed Refer to Specifications section.
50 Hour Maintenance
Component Action Required General Information
100 Hour Lubrication
Component Action Required General Information
Lateral Tilt Pivot Pin - If
Equipped
Lubricate one fitting One fitting at bottom center of lateral
tilt frame.
Lateral Tilt Rollers - If
Equipped
Lubricate one fittings One fitting on each end of lateral tilt
frame.
Axle Couplers Lubricate four fittings One fitting on each inner and outer
coupler, both sides.
Tailings Return Torque
Limiter
Lubricate two fittings Two fittings located right side of
combine.
Clean Grain Elevator
Torque Limiter
Lubricate two fittings Two fittings right side of combine.
Rotary Screen Drive Idler Lubricate one fitting Fitting inside rotary screen.
100 Hour Maintenance
Component Action Required General Information
Wheel Lug Nuts and Bolts Check wheel lug torque.
250 Hour Maintenance
Component Action Required General Information
Engine Oil and Oil Filters (If
the combine operates under
heavy loads and extremely
dusty conditions, change the
oil and filters 125 hours)
Drain crankcase, install new filters. Refill
crankcase to correct level with new oil of
type recommended.
Clearly indicate that the engine oil has
been drained and the combine engine
must not be started.
Final drive Housings Check oil level and fill if necessary. Check
breather.
Hydraulic Oil Pressure
Filter Element
Replace the filter
Lateral Tilt Filter Replace filter element.
Transmission Housing Check oil level and fill if necessary. Check
breather.
500 Hour Lubrication
Component Action Required General Information
Transmission Shift Linkage Lubricate one fitting One fitting on right-hand side of
transmission
Brake Shaft Bearings Lubricate two fittings Two fittings under cab floor.

Related product manuals