ENG
4.0
GLT
Ω
L
IFT
O
PERATION AND
M
AINTENANCE
M
ANUAL
Page | 42
EXIT SEQUENCE
STEP
ACTION NOTES
1
Bring the car to the next floor above the pit by traditional call.
• Visible:GREEN light
2
Press the emergency stop (red button).
• Visible:RED light
3
Turn the selector switch on the maintenance push-button panel to
“automatic operation”.
• Visible:RED light
4
Lower the “CAR” pedestal from the vertical position to the horizontal
position.
• Visible:RED light
5
Lower the “COUNTERWEIGHT” pedestal from the vertical position to the
horizontal position.
• Visible:RED light
6
Detach the ladder from its storage housing and place it ready to climb out
of the pit.
• Visible:RED light
7
Open the landing door to the pit by pulling the lock release cable on the
door.
• Visible:RED light
8
Climb out of the pit up to the entrance landing.
• Visible:RED light
9
Put the ladder back into its storage housing.
• Visible:RED light
10
Release the emergency stop (red button).
• Visible:RED light
11
Close the landing door.
• Visible:RED light
12
Turn the key on the “RESET” switch outside the landing to reset the
electrical panel functions (buzzer).
• Visible: no light
13
The lift is back in service (floor call buttons are not lit).
• Visible: no light
IMPORTANT!
When exiting the pit and/or the car roof, the maintenance technician is advised to ensure that no
equipment or tools have been left behind that can impair smooth operation of the lift or even
cause accidents.
To Next Page
Loading...