ENG
4.0
GLT
Ω
L
IFT
O
PERATION AND
M
AINTENANCE
M
ANUAL
Page | 44
EXIT SEQUENCE (PIT)
STEP
ACTION
1
Press the emergency stop (red button).
2
Turn the selector switch on the maintenance push-button panel to “automatic operation”.
3
Detach the ladder from its storage housing and place it ready to climb out of the pit.
4
Open the landing door to the pit by pulling the lock release cable on the door.
5
Climb out of the pit up to the entrance landing.
6
Put the ladder back into its storage housing.
7
Release the emergency stop (red button).
8
Close the landing door.
IMPORTANT!
When exiting the pit and/or the car roof, the maintenance technician is advised to ensure that no
equipment or tools have been left behind that can impair smooth operation of the lift or even
cause accidents.
ENTRY SEQUENCE (ROOF)
STEP
ACTION
1
Walk up the building’s stairs to the floor where you have decided to access the car roof.
2
Open the landing door to the car roof with the emergency key.
3
The lift is out of service (floor call buttons are lit up).
4
Press the emergency stop (red button).
5
Climb onto the car roof.
6
Close the landing door.
7
The maintenance technician can now work on the car roof without moving the car, e.g. to clean or carry out
maintenance operations, etc.
To Next Page
Loading...