THE CONFIGURATION WEB PAGE DOES NOT SHOW ANY OUTPUT?
► Press ‘F5’ to refresh the web page. Then return to the output panel. If the output still
does not appear, go to the next step.
► Open a TELNET session:
Telnet <IP address> 9999
Login: root
Password: gtmt
Enter “factory_default”, refresh the web page.
► If the output still does not appear, remove the server cover. Check the black cables are
connected correctly and switch the switches are configured (see Appendix C –
MAINTENANCE).
THE DISPLAY SHOWS “NO TIME CODE!”
► “NO TIME CODE!”: The device is not synchronised: check your time source.
► “no time code!” followed by the date: if your device receives the time code, check in
the input panel of the configuration web page that “Enable autonomous mode” is
unchecked.
To Next Page
Loading...