Gorgy Timing LEDI NETWORK TDS V1 - File Transfer; Restart Button

To Next Page

To Previous Page

MDE-LEDI-NETWORK-TDS-4099V3.0

H. File transfer

The SSH protocol can also be used to transfer files between the product and other devices

on the same IP network.

Under Windows

There is no application included in Windows to allow you to transfer a file from/to a Gorgy

Timing product via SSH. You will need to install a client such as Putty.

With Putty: run cmd.exe then type pscp <src> <dst> replacing <src> with the path of

the source file and <dst> with the destination path. The path on the Gorgy Timing product

should be written as follows: <user>@<IP>:FLASH0/<path> replacing <user> with the

username used on the product, <IP> with the IP address and <path> with the path of the

desired file/folder. For example, to import the key of an SSL certificate on a product:

pscp ssl.key root@192.168.0.128:FLASH0/.cfg/

Under Linux

To connect to a Gorgy Timing product in SSH, launch a terminal and enter scp <src>

<dst> replacing <src> with the path of the source file and <dst> with the destination path.

The path on the Gorgy Timing product should be written as follows:

<user>@<IP>:FLASH0/<path> replacing <user> with the username used on the product,

<IP> with the IP address and <path> with the path of the desired file/folder. For example, to

import the key of an SSL certificate on a product:

scp ssl.key root@192.168.0.128:FLASH0/.cfg/

I. "Restart" Button

Use the Restart button at the bottom of the page to restart the device remotely via the Web

page. After pressing the button, the device will be unavailable for about 1 minute until it has

finished rebooting.