MDE-LEDI-NETWORK-TDS-4099V3.0
Use of status commands
The status commands display the state of a time server element. Some commands use
arguments to specify their functioning. For instance, to know if the NTP input is enabled:
Use of configuration commands
Most of the configuration commands can be used as status commands to display the current
value of a setting.
To modify a setting, the new value must be given at the end of a command. For instance, to
disable the NTP input:
Displayed warnings
In interactive mode the warnings listed may appear either at the login on the welcome
message or on a new line. If a command has been launched when a warning should appear,
the warning is only displayed after the result of the command is displayed.
Re-connection to the web
interface in 1 minute…
The Ethernet interface is rebooting.
Updating firmware
Do not reset nor shut down the
product.
This Ethernet interface is recording its new firmware
in flash.
Restarting the product with the RESET button or with
a power failure and an empty battery makes the time
server unusable.
Firmware corrupted
Do not reset nor shut down the
product.
Please reupload a firmware.
The flash firmware in this Ethernet interface is
corrupted.
Restarting the product with the RESET button or with
a power failure and an empty battery makes the time
server unusable.
The firmware must be reuploaded to this interface to
replace the corrupted firmware.
> sync_input ntp en false
To Next Page
Loading...