This section provides answers to frequently asked questions about using your NTP device.
First of all, make sure that the GTNetworkManager2 software is installed on your computer.
I HAVE RUN A SEARCH USING GTNETWORKMANAGER2, BUT I CAN’T
DETECT A DEVICE!
► Check the cable connection. If the ETHERNET LEDs are visible, the LED at the top left
should light up green. Otherwise, there must be a network connection error or a power
issue.
► If you are using several VLANs (Virtual Local Area Networks), check that the device is
on the same VLAN as your computer.
► Connect your computer directly to the device using a direct cable. The device
automatically takes an IP address (format 169.254.x.y). Change the IP address of your
computer to this type by using a network mask 255.255.0.0.
I CANNOT OPEN THE CONFIGURATION WEBPAGE!
► Firstly, can GTNetworkManager2 detect the device?
➔ YES
Your computer and the device must have the same IP address and the same network
mask,
➔ NO
See the question above.
► Has the browser found the web page (loading begins, but fails after a while)?
➔ NO, PAGE CANNOT BE FOUND
If you are using “Internet Explorer”, go to:
Tools
→
Internet Options
→
Connections
→
Network Settings
The browser must not use a proxy. Clear all the check boxes.
➔ YES
The web page can be attached, but the browser is unable to load it. Open a TELNET
session:
Telnet <IP address> 9999
Login: root
Password: gtmt
Enter “factory_default”, refresh the web page.
To Next Page
Loading...