Gorgy Timing LEDI NETWORK TDS V1 - EXPLANATION OF SAFETY SIGNS ON THE PRODUCT

MDE-LEDI-NETWORK-TDS-4099V3.0
3
ENGLISH
General hazard – there is a risk of damage to the product if instructions are not followed
Electrical hazard – there is a risk of electrocution or personal injury if instructions are not
followed.
Equipment fully protected by double insulation.
Warnings
Please follow the precautions and instructions indicated below in order to ensure the safety of you and
your environment, and to prevent any potential damage to your device.
WARNING: An isolating switch in compliance with EN60947 standards is used as a
disconnecting device. It must be easily accessible and installed close to the power supply. It
must disconnect all active poles.
The LEDI
®
NETWORK TDS is intended for indoor use only, at an altitude of less than 2000
metres.
Waste disposal by users in private households within the European Union
This symbol on the product or its packaging indicates the product must not be disposed of with
your general household waste. Instead, it is your responsibility to dispose of your waste by
taking it to a designated collection point for the recycling of electrical and electronic appliances.
The separate collection and recycling of your waste contributes to the conservation of natural
resources and helps to ensure that recycling is environmentally and health friendly. For more
information about your nearest recycling centre, please contact the shop where you purchased
your device, the household waste disposal services or your local authorities.
Technical features
TDS v1
TDS GPS Rail Din TH 35
Power supply
Voltage
110-250 Vac
18-72 VDC
Frequency
50-60Hz
Maximum current
0.1-0.2 A Max
Dimensions
Length
482 mm
209 mm
Width
266 mm
136 mm
Height
44 mm
73 mm
Operating conditions
Maximum operating temperature
50°C
55°C
Humidity (non-condensed)
90 %
EXPLANATION OF SAFETY SIGNS ON THE PRODUCT