► Step 2
► Static mode:
This menu allows you to set up:
- The IPv4 address (IP field),
- The sub-mask (MASK field)
- The network gate (GATE field).
The field being modified flashes on the screen.
Use the “ ↑ ” and “ ↓ ” arrow keys to change the field value.
Use the “ → ” and “ ← ” arrow keys to switch between fields.
Use the “ESC” button to cancel the changes and return to the previous menu.
Use the “OK” button to validate the new IPv4 configuration and move on to step 3.
► DHCP mode:
This mode enables the DHCP client to obtain network settings automatically from
a DHCP server on the network.
Use the “ESC” button to cancel modifications and return to the previous menu.
Use the “OK button to validate the new IPv4 configuration and go to step 3 if the
settings have changed. Otherwise, go to the main menu.
► Steps 3 and 4
The server records the new settings (“WRITING TO FLASH” message) then reboots
(“REBOOTING” message) immediately after.
It is forbidden to attempt to stop the device or to disconnect the device
from its power sources until the product has rebooted completely. This
last step is complete when the device displays the date, time and
synchronisation screen.
To Next Page