MDE-LEDI-NETWORK-TDS-4099V3.0
► From NTPServ 2.00 firmware release including 17.292:
The “Restart” button is available on Web pages with settings requiring the server to be
restarted when modified.
After clicking “Save Settings”, the message “Warning! A reboot is required to apply some
changes saved.” appears above the “Save Settings” button. The user may continue to
change the settings on different Web pages and restart the server once all the settings
have been configured or choose to restart the server immediately by clicking the
“Restart” button. The time outputs are then interrupted for a few seconds while the server
reboots.
When the Ethernet interface is in one of the sensitive states defined below, these Web pages
are replaced with a warning page.
Re-connection to the web interface
in 1 minute…
This Ethernet interface is rebooting.
Updating firmware
Do not reset nor shut down the
product.
This Ethernet interface is writing its new firmware in
flash.
Restarting the device with the RESET button or by
removing the power supply or battery makes the
time server unusable.
Firmware corrupted
Do not reset nor shut down the
product.
Please reupload a firmware.
The flash firmware in this Ethernet interface is
corrupted.
Restarting the product with the RESET button or by
removing the power supply or battery makes the
time server unusable.
The firmware must be sent back to this interface to
replace the corrupted firmware.
To Next Page
Loading...