POLAR PULSE
► Alarm: alarm indicator (power, open serial circuit, parallel short-circuit).
► Output time: displaying the time sent to impulsion clocks.
► Period: impulsion selections every 30 or 60 seconds.
► Impulsion Duration: adjustment of the impulsion duration in quarters of a second.
► 12/24 Hours Format: allows the selection of the time format distributed to the
standard 0 to 23 hours (digital clocks|) or to the standard 1 to 12 hours (analogue
clocks).
► Relative Correction: allows you to add or subtract a number of impulses from 1 to 9
without modifying the time sent (example of application: polarity adjustment).
► Absolute Correction: adjustment of the distributed time on impulsion clocks.
Start-up procedure:
► Check the box “Disable the output card” and then press “Save Settings” to stop
pulse from being generated.
► Connect the clock line to the back slot.
► Set the offset and the DST policy.
► Set the period, pulse duration and format.
► Note the hour and minute displayed by the receiver clocks.
To Next Page
Loading...