The use of the LEDI
®
Network TDS V1 has several advantages:
► Ethernet + IP network interfacing.
► Simplified installation.
► Easy remote configuration and diagnostics.
► 1U 19” rack easily mounted in many installations.
► 3 configurable outputs:
- AFNOR NFS 87500 / IRIG-B
- NTP (V2, V3, V4): Unicast, Multicast et Broadcast
- Minute Impulses 24V //
ASSEMBLY
The rack must be fixed in a 19'' frame using 4 screws and cage nuts, shown in the image
below. (Screw 10-32 M6, tightening torque: 1.13Nm).
BOX CONTENTS
The box should contain the following items
► The 19" 1u rack, with the words "LEDI
®
NETWORK TDS" on the front panel
NOTE: The device code and configuration can be checked on the identification label on the
bottom or back of the device. It must correspond to the following number: 94031/opt (opt
depending on the device options).
► A non-locking IEC 60320 C13 mains power cable
NOT: only for models with alternative current (AC) supply.
► A 2-pin connector for DC power input
NOTE: only for DC models.
► One RJ45 network cable
► A DVD containing software and documentation
☛ Please contact customer service if an item is missing
To Next Page
Loading...