15
Part Three | Out of Box Assembly
Task 3 - Installing the Handlebars (continued)
1. Close and hold the clamp, and loosely screw
in the clamp screw.
1. Hold the handlebars at the desired angle and
tighten the clamp screw.
1. Open the handlebar levers (shown in
blue).
1. If desired, extend the handles outward to
improve the reach of the machine.
2. Twist the controls vertically until they are
comfortable to hold and operate.
1. Once you are comfortable with the position
of the handles, close the handlebar levers.
4
5
6
7
8
9
Clamp Screw
To Next Page
Loading...
Need help?
General
