17
Part Three | Out of Box Assembly
Task 4 - Connecting the Display
Parts & Tools Needed:
Instructions
Take the following steps to install the display.
7-Inch Touch Display
Display Box
SBHCS Screw
M5 x 16 mm (x2)
Display Box
T-handle Allen
Wrench 3 mm
3 mm
Display Cable
Display Box
1. Tilt the display back and line it up in front of
the machine with the cable guide on the
right hand side.
1
1. Use the 3 mm Allen wrench and two M5 x
16 mm SBHCS to secure the display to the
machine.
2
Cable Guide
SBHCS
M5 x 16 mm (x2)
1. Tilt the display to your desired angle.
3
1. Plug the display cable into the top of
the display. Use the end of the cable that
will take the cable towards the side of the
display.
4
To Next Page
Loading...
Need help?
General
