53
The edge warning alert system helps you stay within a “safe area” of your quilt by notifying you when
you approach the edge of a set boundary. This will help prevent the machine from hitting the rails of
the frame, but you can also set boundaries around a particular block or section of the quilt.
To access the edge warning tool, tap on the Toolbox at the bottom of any quilting mode screen
and select Edge Warning.
1
Move your machine so that your needle is at the top left corner of the area you want to mark as
your safe area. Press the set button.
2
Tip: You can also use the start/stop
quilting button on the right handlebar to
set the corners of the “safe area.”
Set
Part Four | Quilting
Note: Edge Warning is automatically deactivated in Baste Mode,
so the alarm will not bother you while tacking down your quilt.
Take the following steps to use the edge warning tool:
Using the Edge Warning
To Next Page
Loading...
Need help?
General
