32
1. Rotate the hand wheel at the rear of the
machine to raise the needle to the top
position
1. Place the thread cone on the cone-style
thread stand toward the front of the
machine.
Thread Stand
1
3
1. Pull the thread straight up, through the
thread mast guide loop above the thread
stand.
Guide Loop
Thread Mast
1. Run the thread through the top hole on
the small thread tensioner. Then slip
the thread between the two discs, and
through the bottom hole of the small thread
tensioner.
Small Thread
Tensioner
4
5
1. Pull the thread around the large thread
tensioner, between the tension discs.
6
Task 10 - Threading the Machine (continued)
Hand Wheel
1. Open the Settings menu by clicking the
menu icon and selecting Settings. This
prevents accidental stitching.
2
Part Three | Preparing to Quilt
To Next Page
Loading...
Need help?
General
