58
• If the bobbin (bottom) thread is pulled through the top layer of fabric, there is too much top
tension. Loosen the tension by turning the large thread tensioner knob toward the setting
“1.” Stop turning the knob when desired tension is achieved.
3
4
1
2
• If the top thread is pulled down through the bottom layer of fabric, there is too little top
tension. Increase the tension on the top by slowly turning the large thread tensioner knob
toward setting “4.” Stop turning the knob when desired tension is achieved.
3
4
1
2
Part Four | Quilting
Adjusting Thread Tension (continued)
To Next Page
Loading...
Need help?
General
