22
Out-of-the-Box Assembly
Lock Collar
Screw
5. Turn the encoder lock collar (shown
in blue) to point up and tighten the lock
collar screw with the 2.5 mm Allen
wrench. Note: Depending on the encoder
model, this step may require the 2.0 mm
Allen wrench.
6
6. Plug the encoder cable into one of the
encoder ports (shown in blue) on the back
of the machine.
7
4. Tighten the encoder screw with the 4 mm
Allen wrench.
5
Encoder
Screw
Installing the Upper Encoder (Continued)
3. Place the encoder screw into the left rear
wheel hole so the encoder O-Ring is
between the two left machine wheels.
4
Encoder O-Ring
To Next Page
Loading...
Need help?
General
