Installation
16 309550ZAP
8. Open cleanoff air valve (K) 1/4-1/2 turn and trigger
gun to check that cleanoff air is flowing. Adjust as
desired.This step does not apply with spatter
pattern spray gun 248408.
9. Engage piston safety lock (L). See Piston Safety
Lock, page 20.
10. Turn on proportioner.
11. Open B (RESIN) fluid valve (about three half turns).
Then open A (ISO) fluid valve.
12. Disengage piston safety lock (L). See Piston
Safety Lock, page 20.
13. Test spray onto cardboard. Adjust pressure and
temperature to get desired results.
14. Apply layer of lubricant over front of gun and lock
ring (R), or use gun cover to prevent overspray
buildup and aid disassembly. See Lubricant for
Gun Rebuild, page 43, to order lubricant and gun
cover.
15. Gun is ready to spray.
K
TI2413A
TI2409A
L
TI2414A
TI2410A
L
TI2645A
R
To Next Page
Loading...
