Graco LineLazer V250SPS - Forward;Reverse Cable Replacement; Removal

Forward/Reverse Cable Replacement
3A3394E Repair - Parts 35
Forward/Reverse Cable
Replacement
Removal
1. If equipped with a Pressurized Bead System,
remove pressurized bead tanks and compressor.
See Pressurized Bead System manual 332230.
2. Remove tank lids and siphon tubes.
3. Remove tanks from unit.
4. Remove six screws and front shield from unit.
5. Loosen four screws and remove belt cover.
6. At the handlebar, remove locknut (3) and ball joint
(40) from handlebar forward/reverse lever. Remove
ball joint (40) from cable (148) and save if not
replacing. Loosen two nuts on cable (148) and
remove from bracket.
7. At the ground drive pump, remove locknut (3) and
ball joint (40) from ground drive pump. Remove ball
joint from cable and save if not replacing. Loosen two
nuts on cable (148) and remove from bracket (62).
8. Install new cable (148) as old cable is removed to
follow same route through frame.
ti19163a
ti19128a
ti23942a
148
3
40
ti19700a
62
40
3
148