Shutdown and Cleaning
24 3A0248C
16. To preserve paint in hose:
a. Point gun into paint pail.
b. Unlock gun trigger lock.
c. Pull and hold gun trigger.
d. Lower prime/spray valve to SPRAY.
e. Turn power switch ON.
f. Continue to hold gun trigger until you see paint
diluted with water starting to come out of gun.
17. While continuing to trigger gun,
quickly move gun to redirect
spray into waste pail. Continue
triggering gun into waste pail
until water coming out of gun is
relatively clear.
18. Stop triggering gun. Engage trigger lock.
19. Lift prime/spray valve to PRIME.
20. Turn power switch OFF.
21. Turn off garden hose. Close Power Flush attach-
ment.
22. Unscrew Power Flush attachment from suction
tube.
23. Clean InstaClean fluid filter and gun, page 24.
24. Fill unit with Pump Armor
™
storage fluid. Read Long
Term Storage, page 25.
Cleaning Gun
• Clean gun fluid filter (d) with
water or flushing solvent
and a brush every time you
flush the system. Replace
gun filter if damaged.
• Remove tip and guard and
clean with water or flushing
solvent. A soft brush can be
used to loosen and remove
dried on material if needed.
• Wipe paint off outside of
gun using a soft cloth moist-
ened with water or flushing
solvent.
NOTE: Step 16 is for returning paint in hose back to
paint pail. One 50-ft (15-m) hose holds approximately
1-quart (1-liter) of paint.
ti8909a
ti13960a
ti5580a
ti12942a
ti8908a
ti13961a
ti2810a
ti9413a
ti2047a
ti9671a
d
To Next Page
Loading...
Need help?
General
