Graco Project Painter Plus 257025 User Manual

Warnings
3A0248C 5
QUICK START-UP GUIDE
WARNING
SETUP
1
Remove spray tip and guard from gun.
2
Connect hose to gun and sprayer.
3
Turn Power Switch OFF. Plug sprayer
into grounded outlet.
FLUSHING
1
Turn Pressure Control Knob left (counter-
clockwise) to minimum pressure.
2
Lift Spray/Prime valve to PRIME.
3
Unclip small drain tube from large suction
tube and place into waste pail.
4
If spraying oil-based materials,* sub-
merge suction tube in paint thinner or
compatible oil-based cleaning solution.
If spraying water-based materials, sub-
merge suction tube in water.
5
Turn Power switch ON. With Spray/Prime
valve still at PRIME, turn Pressure Con-
trol Knob to right (clockwise) until pump
starts.
6
Allow fluid to flow out of prime tube, into
waste pail, for 30 to 60 seconds. turn
power switch OFF.
ti14955a
OFF
ti14953a
ti13961a
WASTE
WATER or
SOLVENT
ti14954a
WASTE
WATER or
SOLVENT

Graco Project Painter Plus 257025 Specifications

General

Brand	Graco
Model	Project Painter Plus 257025
Category	Paint Sprayer
Language	English