Maintenance and Service*
3A0248C 27
Maintenance and Service*
Caring for Sprayer
Keep sprayer and all accessories clean and in good
working order.
To avoid overheating motor, keep vent holes in shroud
clear for air flow. Do not cover sprayer while spraying.
Paint Hoses
Check hose for damage every time you spray. Do not
attempt to repair hose if hose jacket or fittings are dam-
aged. Do not use hoses shorter than 25 ft (7.6 m). Use
two wrenches to tighten.
Tips
• Always clean tips with compatible solvent and brush
after spraying.
• Tips may require replacement after 15 gallons (57
liters) or they may last through 60 gallons (227
liters) depending on abrasiveness of paint.
• Do not spray with worn tip.
* The Project Painter Plus is a non-repairable sprayer. Please refer to
the Part List (page 32) for a list of replaceable parts.
NOTICE
Protect the internal drive parts of this sprayer
from water. Openings in shroud allow cooling of
mechanical parts and electronics inside. If water
gets into these openings, the sprayer could malfunc-
tion or be permanently damaged.
ti2776a
ti14967a
ti2055a
To Next Page
Loading...
Need help?
General
