Shutdown and Cleaning
3A0248C 23
Power Flush
Power flushing is a faster method of flushing. It can only
be used after spraying water-based coatings.
1. Relieve pressure, page 14.
2. Remove tip and guard assembly from gun and place
in waste pail.
3. Place empty waste and paint pails side by side.
4. Lift suction tube and prime tube from paint pail. Let
them drain into paint for a while.
5. Place suction and prime tube in waste pail.
6. Turn Pressure Control knob to the Prime/Clean set-
ting.
7. Screw power flush attachment to garden hose.
Close valve.
8. Turn on water. Open valve. Rinse paint off suction
tube, prime tube and inlet screen.
9. Turn lever to close power flush attachment.
10. Unscrew inlet screen from suction tube. Place inlet
screen in waste pail.
11. Connect garden hose to suction tube with Power
Flush attachment. Leave prime tube in waste pail.
12. Turn power switch ON.
13. Open lever on Power Flush attachment.
14. Circulate water through sprayer, into waste pail, for
20 seconds.
15. Turn power switch OFF.
ti9726a
ti12940a
ti9413a
ti9413a
ti2040a
ti2042a
ti5580a
OPEN
ti2043a
ti2018a
To Next Page
Loading...
Need help?
General
