Warnings
8 3A0248C
QUICK START-UP GUIDE
SHUTDOWN AND CLEANING - WATER-BASED PAINTS*
8
Turn power switch OFF. Remove power
flush attachment from suction tube.
9
Clean tip, guard and inlet screen with a brush. Remove filter from spray gun, and
clean with a brush. Reassemble spray gun guard/tip and filter.
10
Submerge suction tube and drain tube in storage fluid. Always use Graco pump armor
or mineral spirits/paint thinner for storage fluid. Lift spray/prime valve to PRIME. Turn
power switch ON.
11
Turn pressure control knob to right
(clockwise) until pump starts.
12
When storage fluid comes out of drain tube,
turn power switch OFF.
13
Lower prime/spray valve to SPRAY.
14
Install inlet screen on suction tube for
storage.
OFF
WASTE
ti13961a
WASTE
OFF
ti14960a
To Next Page
Loading...
Need help?
General
