Flushing
26 332144E
Flushing
• Generally, flush if you will be shut down for more
than 3 days. Flush more often if material is moisture
sensitive and humidity is high in the storage area, or
if material may separate or settle out over time.
• Flush out old fluid with new fluid, or flush out old
fluid with a compatible solvent before introducing
new fluid.
• Use the lowest possible pressure when flushing.
• Always leave some type of fluid in system. Do not
use water.
• For long term storage, flush out the solvent with a
storage fluid such as Bayer Mesamoll plasticizer or,
at minimum, clean motor oil.
1. Engage piston safety lock or trigger safety lock.
Close fluid valves ISO and RES. Leave air on.
2. Set function knob to Stop/Par k .
3. Shut off Heater Power. Allow system to cool.
4. Remove recirculation tubes (P) from supply tanks
and place in original containers or waste containers.
5. Turn Recirc/Spray valves to Recirc.
6. Set function knob to Fast Recirc . Pump mate-
rial from supply tanks until no more comes out.
7. Set function knob to Stop/Par k .
8. Wipe out any remaining material from the supply
tanks. Fill each supply tank with 1-2 gal. (3.8-7.6 l)
of solvent recommended by your material manufac-
turer.
9. Set function knob to Fast Recirc . Pump solvent
To avoid fire and explosion:
• Flush equipment only in a well-ventilated area.
• Ensure main power is off and heater is cool before
flushing.
• Do not turn on heater until fluid lines are clear of
solvent.
Fusion
Probler
1
2
3
4
5
6
7
8
9
10
0
+
-
ti21490a
P
ti21495a
1
2
3
4
5
6
7
8
9
10
0
+
-
ti31496a
1
2
3
4
5
6
7
8
9
10
0
+
-
ti21490a
To Next Page
Loading...
Need help?
General
