106
Sliding Latch Plate and ALR Retractor
A latchplate that slides freely on the belt
webbing and cannot, by itself, hold the belt
snug around a car seat.
Slowly pull the shoulder belt all the way
out. Route the vehicle seat belt through the
proper belt path and buckle it in. Then, as you
pull the vehicle seat belt tight, feed all the slack
back into the retractor.
Grab the sides of the seat at the belt path and
slide the seat side-to-side and front-to-back.
The seat should not move more than 1” (2.5
cm).
NWL0001077519C SlimFit3 LX USA ENG R04 (8BZ20.indd 106NWL0001077519C SlimFit3 LX USA ENG R04 (8BZ20.indd 106 9/18/20 11:50 AM9/18/20 11:50 AM
To Next Page
Loading...
